AIRLESS atomization, under high pressure without any atomizing air delivered to the spraygun, allows the spraying of high viscosity product, a precise fan width determined by the angle of the tip chosen and the spraying of thick coats of paint.
■ Full stainless steel fluid passage
■ 50 years of experience
■ High cycling rate (opening/closing)
Medium to high viscosity primers, anti-corrosion paints, structural paints, U.V paints, released agents, underbody coatings, oil and glues.
► Simple construction with limited number of parts : Durability & Reduced cost of ownership
► Compact and light weight
► Easy servicing and cleaning
IN THE GUN (2)
|▪ To apply low to semiviscous material with limited pressure loss
▪ Heated fluid installation to
prevent product settlement
|▪ Spring for 240 bar
operating pressure (ASI 24)
▪ Spring for 400 bar operating pressure (ASI 40)
|FULL STAINLESS STEEL PASSAGE (3)
||NEEDLE BALL (5)
|Compatible with a large range of products including waterborne, high solids and U.V paints.
||Two different needle ball sizes
for optimal performance and
minimal laminar wear upon material viscosity.
|RULON OR GT SEAL CARTDRIGE (4)
||NO TIPS SEAL NEEDED (6)
|Strong resistance to very
abrasive coating (high solids and U.V paints) for extended lifetime.
|Spray tip mounted directly on diaphragm without seal.
|BALL SEAT CONSTRUCTION (5)
||GUN MOUNTING (7)
|Nickel carbide ball with
carbide seat for higher durability.
|Simple mounting on 8 mm round bar. Easy adjustment.
BACK TO THE PRODUCTS LIST